HUDCO FORMULA 5100

Ballistic Grade Aramid Fiber Reinforced High Temperature Wear Compound

High Temperature Version of Formula 5000 Application where other Epoxies would fail

HUDCO Formula 5100 combines high-strength, high temperature epoxy resins with a dense loading of wear-resistant alumina and silicon carbide ceramic aggregate. Used as an easy- to-apply coating, HUDCO Formula 5100 is a cost-effective alternative to the installation of wear-resistant ceramic tile in high temperature applications. Repairs to worn equipment made with Formula 5100 provide the advantage of a prolonged wear life far beyond that of the original part.

Reinforced with Ballistic Grade Aramid Fiber

HUDCO in 1994 formulated Formula 5100 to include ballistic grade aramid fiber reinforcement in the polymer matrix. The addition of ballistic grade aramid fiber, one of the toughest materials in existence, has significantly improved the phenomenal properties of HUDCO Formula 5100. The unique concept of using ballistic grade aramid fiber to reinforce the matrix of HUDCO Formula 5100 demonstrates HUDCO's commitment to world class technology.

Beneficial Properties of Hudco Formula 5100

Can be used for wear-resistant protection or repairs. Does not shrink or expand. Provides wear life far beyond that of the original part. Conforms quickly to odd shapes. Requires no special application skills.

Pysical Properties of Hudco Formula 5100

• Compressive Strength ASTM D-695................17,000 PSI
• Heat Deflection Temperature ASTM D-648.......325 °F
• Tensile Strength ASTM D-638.........................8,500 PSI
• Pot Life @ 77 °F................................25 minutes
• Gel Time.......................................................45 minutes
• Shelf Life.......................................................1 year

Instructions:

Surface Preparation:
Roughen surface by grinding or sandblasting (3-5 mil surface profile). Surface must be completely dry with a minimum surface temperature of 75°F.

Mixing:
Mix 4 part of resin to 1 part of hardener by weight. Kits are supplied in the correct ratio. Ensure that the sides of the mixing container are scraped into the mixture. Mix several minutes, until consistent color is achieved.

Application:
Apply product to prepared surface and use supplied tools to achieve desired finish.

Curing:
At 75°F, product will gel in 30 min. Initial cure will occur in 3 Hours. In order for the product to reach its 325°F potential, it must be post cured for 8 hours at a temperature of 200°F or higher.

Safety Precautions:

Industrial use only. Keep away from children.

Always use in well ventilated areas. Prolonged exposure to resin or hardener may cause sensitization and/or dermatitis. If eye contact occurs, irrigate promptly with clean water for 15 minutes and call physician. Wash with soap and water any areas of skin which come in contact with product. In the case of inhalation, remove to fresh air and provide oxygen if necessary. If ingestion should occur, call a physician at once.

Storage:

This product has a shelf life of 1 year and must be stored at a temperature between 70°F and 85°F.

Warranty:

Because the storage, handling and application of these materials are beyond our control, we can accept no liability for the results of their use. Our liability is limited only to replacement of any material proven defective in manufacture.