Hudco CMP Ceramic Surface

HUDCO CMP CERAMIC SURFACE is the best prevention to expensive failures. It is a lower viscosity version of Ceramic Rebuild, And is designed to coat metal equipment subject to corrosion, cavitation and chemical attack where a "diamond hard", smooth, glassy surface is desired. Ceramic Surface is excellent when applied to new equipment to further extend its surface life, especially where fluid dynamics play a major role.

Ceramic Surface CANNOT be machined; however, it can be ground in localized areas, if necessary, to obtain clearances.

HUDCO CMP Ceramaic Surface applications include:

• Pumps
• Impellers
• Screw Conveyors
• Valves
• Heat Exchanger Tube Sheets

Properties

• Mixing Ratio: 7:1 by Weight
• Maximum Operating Temperature 250°F
• Pot Life: 20 Minutes
• 100% Cure: 48 hours
• Machinable: No
• ASTM D 695 Compressive Strength: 14,400 PSI
• ASTM D 1002 Lap Shear: 4,450 PSI
• Color - Resin: Blue
• Color - Hardener: Amber
• Color - Mixed: Blue
• Viscosity: Light Paste
• ASTM-C881 Shrinkage: Pass Barcol
• Hardness: 36 Matrix Only
• Specific Gravity: 1.55 Mixed
• Shelf Life: 1 Year
• Coverage: 2.2# Kit - 7.6 Square Feet, 25 Mils. Thick
• 4.4# Kit - 15.2 Square Feet, 25 Mils. Thick

Instructions

Surface Preparation: Roughen surface by grinding or sandblasting (3-5 mil profile). Surface must be completely dry with a minimum surface temperature of 75°F.

Mixing: Mix 7 parts of Resin to 1 Part of Hardener by weight. Kits are supplied in the correct ratio. Ensure that the sides of the mixing container are scraped into the mixture. Mix several minutes, until consistent color is achieved.

Application: Apply product to prepared surface and use supplied tools to achieve desired finish.

Curing: At 75°F, product will gel in 20 min. Initial cure will occur in 6 - 8 hours. Final Cure occurs in 1 Day. Curing can be accelerated by heating the applied product to 140°F. Product properties will also be improved by curing at this elevated temperature.

Safety Precautions:

Industrial use only. Keep away from children.

Always use in well ventilated areas. Prolonged exposure to resin or hardener may cause sensitization and/or dermatitis. If eye contact occurs, irrigate promptly with clean water for 15 minutes and call physician. Wash with soap and water any areas of skin which come in contact with product. In the case of inhalation, remove to fresh air and provide oxygen if necessary. If ingestion should occur, call a physician at once.

Storage:

This product has a shelf life of 1 year and must be stored at a temperature between 70°F and 85°F.

Warranty:

Because the storage, handling and application of these materials are beyond our control, we can accept no liability for the results of their use. Our liability is limited only to replacement of any material proven defective in manufacture.