Hudco CMP Metal Fix

HUDCO CMP METAL FIX employs a Synergistic mixture of laboratory tested, proven polymers and metals which provides excellent repair capabilities for damaged metal. Metal Fix forms an exceptionally strong bond to many substrates, including steel, cast iron, stainless steel, wood, concrete and many rubbers and plastics. Its smooth machinability, using common metal cutting equipment, is particularly useful for precision repairs of complex metal structures and components. Metal Fix cures at temperatures down to 32 degrees F enabling repairs to be made in adverse conditions.

Permanent Repairs With HUDCO CMP METAL FIX include:

• Scored/worn areas on shafts
• Cracked castings with exception strength
• Worn out bearing housing to new specs
• Scored hydraulic rams
• Heat exchange housings
• Valve bodies
• Damaged keyways

• Specific Gravity: 2.3
• Mixing Ratio: (R:H): 2:1 by Weight
• Color: Grey
• Pot Life: 40 Minutes at 75°F
• Initial Cure Time: 6 - 8 hours at 75°F
• Final Cure Time: 24 Hours at 75°F
• Maximum Operating Temperature: 200°F
• Compressive Strength: 12,100 PSI
• Lap Shear Strength: 4,200 PSI

Instructions

Surface Preparation:
Roughen surface by grinding or sandblasting (3-5 mil profile). Surface must be completely dry with a minimum surface temperature of 75°F.

Mixing:
Mix 2 parts of Resin to 1 Part of Hardener by weight. Kits are supplied in the correct ratio. Ensure that the sides of the mixing container are scraped into the mixture. Mix several minutes, until consistent color is achieved.

Application:
Apply product to prepared surface and use supplied tools to achieve desired finish.

Curing:
At 75°F, product will gel in 20 min. Initial cure will occur in 6 - 8 hours. Final Cure occurs in 1 Day. Curing can be accelerated by heating the applied product to 140°F. Product properties will also be improved by curing at this elevated temperature.

Safety Precautions:

Industrial use only. Keep away from children. Always use in well ventilated areas. Prolonged exposure to resin or hardener may cause sensitization and/or dermatitis. If eye contact occurs, irrigate promptly with clean water for 15 minutes and call physician. Wash with soap and water any areas of skin which come in contact with product. In the case of inhalation, remove to fresh air and provide oxygen if necessary. If ingestion should occur, call a physician at once.

Storage:

This product has a shelf life of 1 year and must be stored at a temperature between 70°F and 85°F.

Warranty:

Because the storage, handling and application of these materials are beyond our control, we can accept no liability for the results of their use. Our liability is limitied only to replacement of any material proven defective in manufacture.