Hudco Slick Stuff

Low Friction Surface Coating

HUDCO Slick Stuff is a coating specially designed to provide a low friction surface. It differs from other surface coatings because it is filled with ultra high density polymer particles and lubricants in a high performance epoxy matrix. Slick Stuff provides excellent fluid flow properties in the moving of liquids and in less abrasive solid applications. Excellent corrosion and chemical resistance properties are also present with this product.

HUDCO Slick Stuff can be applied with a paintbrush of suitable width. It forms strong durable bonds to steel, concrete, fiberglass, and other similar substrates.

Apply Slick Stuff in situations where abrasion is not a major concern, but fluid material flow is desired.

Packaging & Coverage

• Kit Size Net Volume Coverage
• 3lb. 0.36 Gallons 15 Square Feet
• 12lb. 1.44 Gallons 60 Square Feet

Properties

• Specific Gravity..............1.00
• Mixing Ratio (R:H)..............5:1 by Weight
• Color .....................Red
• VOC ....................100% Solids
• Application Thickness .........................20-30 mils/coat
• Cure Time.............................................24 hours @ 75°F
• Gel Time................................................4 hours @ 7°F
• Pot Life.......................................25 minutes @ 75°F (200 gram mass)

Instructions

Surface Preparation:
Roughen surface by grinding or sandblasting (3-5 mil profile). Etch Aluminum with 10-15% phosphoric acid and flush with alkaline water , then dry. Surface must be completely dry with a minimum surface temperature of 75°F Surface Test: Place one drop of distilled water onto prepared surface. If water heads, Surface is not suitably clean. If water flows easily and drop flattens, surface is ready.

Mixing:
Mix 5 parts of Resin to 1 Part of Hardener by weight. Kits are supplied in the correct ratio. Ensure that the sides of the mixing container are scraped into the mixture. Mix several minutes, until consistent color is achieved.

Application
Apply to prepared surface with brush of suitable width. Keep brush very wet with product to insure proper coating thickness. Apply additional coating, if desired, immediately after Gel Time (4 Hours) expires.

Curing:
At 75°F product will gel in 4 hours (at 20 mil thickness). Product will cure completely in 24 hours.

Safety Precautions

Industrial use only. Keep away from children. Always use in well ventilated areas. Prolonged exposure to resin or hardener may cause sensitization and/or dermatitis. If eye contact occurs, irrigate promptly with clean water for 15 minutes and call physician. Wash with soap and water any areas of skin which come in contact with product. In the case of inhalation, remove to fresh air and provide oxygen if necessary. If ingestion should occur, call a physician at once.

Storage

This product has a shelf life of 1 year and must be stored at a temperature between 70°F and 85°F.

Warranty

Because the storage, handling and application of these materials are beyond our control, we can accept no liability for the results of their use. Our liability is limitied only to replacement of any material proven defective in manufacture.